NOX-RUST X-110-DLS Transparent, Water Displacing Wax Corrosion Preventive Compound QPL Approved Mil Spec MIL-PRF-16173E Grade 4, Class I
NOX-RUST X-110-DLS is a Qualified Product Listed (QPL) for Govt Designation MIL-PRF-16173E; Grade 4, Class I, formulated to also fulfill the requirements of MIL-P-116J, Type P-19 Specifications.
Contrary to Class II, Class I indicates this product is higher in Volatile Organic Content/Compounds (VOC), exceeding 2.8 lbs. per gallon (340 grams/liter).
NOX-RUST X-110-DLS is a firm, solvent-based, water-displacing wax corrosion inhibitor compound cut back with mineral spirits designed to provide superior long-term protection of in and outdoor corrodible metal parts with/without covering during storage and transportation.
NOX-RUST X-110-DLS will cure to a transparent, amber, firm wax film that is non-tacky granting a clean and convenient solution for effective corrosion prevention while preserving the integrity and appearance of the applied surfaces.
NOX-RUST X-110-DLS is the ultimate protection for long-term storage or shipping of manufactured cast and forged steel roles used in various rolling industries.
An excellent choice for long-term, high-quality corrosion prevention for a wide range of application requirements in vehicle rustproofing, protection of general machinery and spare parts in long/short haul shipments and storage.
Product Uses:
- Translucent, Amber-Colored, Corrosion Preventive Coating recommended for corrosion prevention for a variety of metal applications such as automatic parts, dies, tubing, machine polished rolls/tools, as well as machinery or spare parts exposed to indoor and outdoor conditions during domestic/international shipments and storage.
- Protects highly polished cold rolled steel and paper calendaring mill rolls during shipping.
- The transparent film permits easy visual inspection of mill roll surfaces for hardness and surface imperfections prior to shipment.
- Will NOT stain silver or silver-plated materials.
- Class I Volatile Organic Content/Compounds (VOC) exceeds 2.8 lbs. per gallon (340 grams/liter).
- Removal is possible with mineral spirits (or another similar petrolatum solvent), hot alkaline wash, or low-pressure steam.
Product Performance:
- When applied at the recommended wet film thickness (WFT) of 2-3 mils over the surface profile, it will deposit the recommended dry film thickness (DFT) of 1 mil.
- Dry to touch and weather-resistant in 4 hours, and fully cured in 24 hours.
- Covers 800 square ft. per gallon when applied at the recommended film thickness.
- Can provide up to 2 months of outdoor protection and 5 years of indoor or undercover protection on metal substrates at the recommended dry film thickness.
Application Equipment Recommendations:
- Pumps with ratios of 15:1 or greater are advised for efficient use of container content.
- Tungsten Carbide Nozzles Tip in the spray gun is recommended. (.015" to .017" tip orifice size)
- High Pressure Fluid Hose of no less than 3/8 in. diameters is suggested for less than 50 ft. of material hose.
- Low Ratio pumps (15-30:1): operate through 100 ft. of 1/2 in & 50 ft. of 3/8 in. hose for a max of 150 ft.
- High Ratio pumps(>30:1): operate through 200 ft. of 1/2 in & 50 ft. of 3/8 in. hose for a max of 250 ft.
- Can be brush or dip applied.
For additional product information as well as storage and handling requirements, refer to the Product Data Sheet or Safety Data Sheet provided on this page.